Related Topics:
Check Active Addresses Switch-
How to configure IP addresses for aggregation layer switch interfaces
This chapter describes how to configure port channels and to apply and configure the Link Aggregation Control Protocol (LACP) for more efficient use of port channels in the Cisco NX-OS devices. 3ad link aggregation enables you to group Ethernet interfaces to form a single link layer interface, also known as a link aggregation group (LAG) or bundle. The LAG balances. This document provides Ethernet link aggregation configuration examples. The configuration examples in this document were created and verified in a lab environment, and all the devices were started with the factory default configuration. Switch models used: JL635A Aruba 8325-48Y8C They run in a high availability pair and use VSX to provide redundancy. It is intended for administrators responsible for installing, configuring, and managing Aruba switches on a network.
[PDF Version]
-
Block IP addresses on the core switch
Step 1: Review the switch configuration to verify that an ingress ACL is applied to all external or CE-facing interfaces. The Cisco PE switch must be configured to block any traffic that is destined to the IP core infrastructure. Core network elements must not be accessible from any external host. Protecting the core from any attack is vital for the integrity and privacy of customer. There is a DMP receiver on our network that is receiving messages predictably one hour a week. I believe the messages are coming from a panel on our network. The classic Access Control List (ACL) is the core mechanism on Cisco network devices (routers, switches etc) which is mainly used for traffic filtering. In this article we will examine a different type of ACL, called the Vlan Access.
[PDF Version]
-
Are the IP addresses of relay protection devices fixed
The relay is still unable to communicate in the IEC 61850 network (missing network address) and its configuration cannot be yet verified using the recommended testing tools.
[PDF Version]
-
Add IP to the core switch
To assign an IP address to a switch, you will need to use the command line. If you are unfamiliar with terms in this document, check out Cisco Business: Glossary of New Terms. This means that you can buy a Cisco switch, plug in the right cables to connect various devices to the switch, power it on, and the switch will work properly. Setting up and managing a Ubiquiti switch through the UniFi Controller can dramatically simplify network management for businesses, home labs, and service providers.
[PDF Version]